Understanding the Benefits of Ceramic Motor Seal
Engine overheat is an inevitable problem in any car, which is also expensive to repair and this happens as a result of head gasket leaks. But don’t worry because there’s an easy alternative for that and it is through the use of ceramic motor seal. Cylinder head gasket leaks are really a problem which causes plague in the internal combustion engine no matter what its model, make or year. Whether it’s due to engine overheat or via high mileage and tear and wear, cylinder head gaskets could leak and also cause issues.
When there’s leak in the cylinder head gasket, this is an indication that there is a leak in engine coolant either to crankcase of the engine or into several cylinders of the engine. If you like to learn more about this, you may visit this site and keep on reading.
There are minor and major issues for the head gasket leaks that you must address. In the former, the car is still in a driveable condition but it will suffer from diminished engine performance, overheating and slow coolant consumption. In more serious cases however, the engine can suffer from major engine performance problems and overheating, blow white smoke out the tail pipes and excess coolant contamination. In a more severe case, the head gasket leak renders the car not suited for driving and need total engine replacement. It’s okay not to immediately deal with the leak on your head gasket, but be ready with the consequences, you can view here.
If you use Irontite, it will work from within of the car by sealing the head gasket leaks by utilizing the car’s cooling passages where it’ll be transported on where the leak is. To know the real problem of your car, it is best to contact a technician first and have them check your engine before you push through with the solution.
Now, assuming that you’re all set and go, here are the things that you need to do.
#1. Read the instructions written at the back of Thoro-Flush to get a clearer idea on how it should be used.
#2. Find the radiator cap and pour in the engine block sealer straight to the engine.
#3. As soon as you are done pouring the right volume of engine block sealer to the engine coolant, be sure that it is just at the right level and get a new cap.
#4. Start your engine and turn on your heater to maximum flow and heat.
#5. Keep the engine in idle for 15 minutes at least or for how long it is instructed on the engine block sealer.
These steps will get your car’s engine running in good condition, so do this now!